Cary Audio Design CAD-280sa, V12i Cary V12i tube stereo amplifier

Selling my beloved Cary
V12i tube amp out of necessity :(  If you're familiar with it, you know all the accolades and positive reviews...HUGE soundstage in every respect -
sounds wider and taller than your house on appropriate recordings, but can also give you the impression of how far Diana Krall's lips are from the microphone. Amazing. Carnival red finish is
perfect and has a beautiful deep gloss to it. It's borderline 9/10 condition, but I'll go with 8/10 only due to age. All I can see is a bit of normal wear on the binding posts, and a light scratch on the back of one of the black transformers (difficult to see, even in photos). I took close up photos in very good lighting to show just how great the condition is. You'll be getting Electro Harmonix EL34's and EL84's, and a fancy pair of Genalex 6922's - all tubes only about a year old with VERY little usage. The asking price is fairly firm, considering the good condition and the fact that I paid almost 3K for it as the second owner. Thanks. 
Below is a link to a Sterophile review and specs. 

http://www.stereophile.com/tubepoweramps/601cary/

CAD-280SA (V-12i)

Weight: 68 lbs.

Dimensions: 8" H x 12.5" W x 18" D 
Circuit Type: Push-Pull, Balanced, Class A Triode, Class AB Ultra-linear

Power Output: 50 Watts - Triode 100 Watts - Ultra-Linear

Inputs: RCA Single-ended, XLR Balanced

Noise and Hum: -86 dB below full output

Input Impedance: 150K ohms

Frequency Response: 20 Hz to 23 KHz +/- .5 dB

Tubes:

12 - EL-34 Output tubes 
2 - EL-84 Current Source Tubes 
2 - 6922 Input Tubes

Power Transformer(s):Dual High-Voltage secondary, one for each channel, EI Laminated 200% duty cycle.

Output Transformer(s): Special EI Laminate, 125-watt power continuous rating

Filament Transformer(s): Two EI Laminate, 12 amp transformers, one for each channel.

Resistors: 1% Metal Film

Capacitors:.33µF Film & Foil

Filter Chokes: Two chokes, one for each high-voltage supply on each channel,Two chokes, one for each bias supply on each channel.

Power Supply Capacitors: 
4 - 560µF@400 VDC 
6 - Film & Foil

Power Supply Regulators: 
2 - MJW 1612, one for each input tube 
6 - Film & Foil

Speaker Posts: Gold plated Copper, Common and 4 - and 8-ohm outputs

AC Cord:3 Conductor Shielded, Detachable

AC Power Requirements: 100 - 240 VAC @ 50/60 Hz (Selected at factory in production)

Warm-Up Time: 3 Minutes

Break-In Time: 100 hours of playing time 
Finish: Multiple coats of Jaguar's Carnival Red with clear coat on chassis, machined aluminum faceplate.

Feet: Large "Soft Shoe" rubber