Audiolab / TAG McLaren Audio 100 Watt Dual Mono Block Amplifier
Listed · 425 Views
1 Watcher
Items from this seller
This listing has ended.
Listings Similar to Audiolab / TAG McLaren Audio
Time Left: None
This listing has ended.
Condition | |
Payment methods | |
Ships from | Lancaster, CA, 93534 |
Ships to | United States |
Package dimensions | 24.0" × 21.0" × 13.0" (65.0 lbs.) |
Shipping carrier | FedEx |
Shipping cost | Log in to see price |
Original accessories | Remote Control, Box, Manual |
Average | Research Pricing |
Last of the English made
Audiolab amplifiers, manufactured in the McLaren Formula 1 Electronics factory
under exacting specs, and marketed as TAG McLaren Audio. Two individual 100
Watt Mono Block amplifiers housed in a single chassis (upgradeable to 5). Comes
with a remote control to individually access the Mono Blocks as well as TAG
McLaren Audio's exclusive Tagtronic Bus allowing full control of the amplifier
to TAG McLaren Audio preamps. Originally sold for $5,000. One of the best
amplifiers in its class, it received top marks from reviewers (see the
following address). http://www.iaguk.com/tag/100x5R_reviews.htm This amplifier was so popular in England that there is still an active user forum dedicated to it, over 12 years after the Chinese bought the company. This is a rare 110V version of the amplifier, less than 100 of these were ever made. The item you are bidding on is in New condition, in original box, including all accessories, with few if any hours on it.
Specifications
rated output power 100 W
into rated load impedance (8 Ohms)
typical output power 120
W per channel into 8 Ohms, 160 W into 4 Ohms and 190 W into 2 Ohms for short
periods
input for full rated
power 1.0 V rms
input impedance 47 kOhm
nominal
gain 29.0 dB at 1 kHz
signal to noise greater
than 90 dB (relative to 0 dbW)
frequency response ±
0.05 dB from (-3 dB) 20Hz to 20kHz; -3dB @ 0.2 Hz and 87 kHz
total harmonic
distortion + noise less than 0.002% @ 1 kHz 100 W into 8 Ohms, less than 0.05%
from 20 Hz to 20 kHz @ 100 W into 8 Ohms
polarity non-inverting
between any input and output
each module has 1 single ended input and 1 set of 5 way binding posts for output
ac supply frequency 50 -
60 Hz
ac supply voltage 100 V,
110 - 120 V power consumption less than 1380 W
dimensions (including
feet, terminals and controls) 445 mm wide, 139 mm high, 352 mm deep
Note: this unit was factory modified from 3 channel to 2 channel, while this is not apparent when observing the unit, the box is marked as originally being 3 channel.
No questions have been asked about this item.
Ask the seller a public question
You must log in to ask a question.
No policies have been specified.