Ortofon Cadenza black

Ortofon Cadenza Black, used less than 10 hours from new.
I purchased this cartridge for my new Merrill Williams 101.2, but shortly
after started using a new Meister Silver SPU from Ortofon, so this cartridge
saw very little use and is not even broken in.......a nice opportunity to get
an as new cartridge for your high end table.......

I also have a nearly new Arche' headshell in aluminum from Acoustical Systems
if you're interested (list 850.00)

You can hear actual cartridge here:
https://www.youtube.com/watch?v=ctaIWCcz9LQ&list=UUmSasMKqZxyvEhCgQPOdaDA

Details on the Ortofon Cadenza Black
The Black model is using a Nude Shibata stylus with a boron cantilever. The effective mass of the stylus/cantilever system is extremely low by using a very thin boron rod. This material is extremely stiff and even more lightweight compared to aluminium. It also uses the WRD (Wide Range Damping-system), controlling the high and low frequency damping separately. Cadenza Black is optimized for an amazing tonal neutrality, dynamics and purity of sound. It is high performing on areas like detail, consistency and sound staging.

Ortofon Cadenza Black Technical Data
Output voltage at 1000 Hz, 5cm/sec. 0,3 mV
Channel balance at 1 kHz 27 dB
Channel separation at 15 kHz > 20 dB
Frequency range at - 3dB 20 - 60.000 Hz
Frequency response 20 Hz - 20 kHz +1,5/0
Tracking ability at 315Hz at recommended tracking force 90 µm
Compliance, dynamic, lateral 16 µm/mN
Stylus type Nude Shibata, Boron cantilever
Stylus tip radius r/R 6/50 µm
Tracking force range 2,0-2,5 g (20-25 mN)
Tracking force, recommended 2,3 g (23 mN)
Tracking angle 20°
Internal impedance, DC resistance 5 Ohm
Recommended load impedance > 10 Ohm
Cartridge body material Stainless steel Aluminium
Cartridge colour Black/Black
Cartridge weight 10,7 gram