TTW Audio The Eliminator Center Damping Weight Reduce Bearing Noise and Center Clamp Records
Listed · 415 Views
2 Watchers
Items from this seller
This listing has ended.
Listings Similar to TTW Audio
Time Left: None
This listing has ended.
Condition | NEW |
Payment methods | |
Contact seller after sale to pay viaVISA/Mastercard, American Express or Certified check | |
Ships from | Newmarket, ON, L3Y 8X8 |
Ships to | Worldwide |
Package dimensions | 4.0" × 4.0" × 4.0" (3.0 lbs.) |
Shipping carrier | USPS |
Shipping cost | Log in to see price |
Original accessories | Box, Manual |
Average | Research Pricing |
This Center Weight will really boost the performance of older idler and direct drives, the mass absorbs a lot of energy and noise from the bearing and effectively center clamps the record.
Be blown away for $ 139.00 10 only!
Material and Engineering Summary:
Universal fit for all turntables, General Use for basic Turntables
Machined from billet 303 Stainless Steel
Dimensions: 3.45 inch diameter by 1.5 inches height
Weight: (2.8 LB/1270 Grams)
Minimum spindle height 1/8
Engineered to Perform
Our Budget flagship center weight features high surface area with 4 holes bored to x .500 x .500 deep on the underside of the weight, the huge surface area improves resonance management and dissipates the energy from the record. A similar technique used in some of our turntable platters.
The 303 Stainless series replaces the original Brass weight and provides better resolution than the Brass Weights, cleaner articulation of the high frequencies and a much improved bass response. The full radiur top face provides superb resonance management and decorative machined features provide an elegant look to any high end table.
The weight is contour machined to clear most large cartridges and is recommended for robust tables only.
Benefits
· Universal Fit, cleaner sound, improved dynamics and frequency response
· 4 holes bored to x .500 x .500 deep on the underside of the weight
· Lower Distortion Levels and bass management and crystal clear and clean high register
· Bored Center holes 32 Micro Inch Surface Finish will not damage spindle
· Clears Spindles 1.0 depth
· TTWeights can be mounted while turntable is turning
· The Spindle bore is not drilled, it is CNC bored to (.284-.285 diameter). +/-.0005 tolerance and is concentric to the outside diameter by .0005 or less.
· The bottom has a concave Radius, .015 deep with a .250 on the outside perimeter for correct seating on the LP perimeter. This increases the contact pressure vs. small diameter weights.
No questions have been asked about this item.
Ask the seller a public question
You must log in to ask a question.
No policies have been specified.