Audio Research vsi75 Integrated Amp Silver
Listed · 2074 Views
6 Watchers
Items from this seller
This listing has ended.
Listings Similar to Audio Research
Time Left: None
This listing has ended.
Condition | |
Payment methods | |
Ships from | Bloomington, IN, 47401 |
Ships to | United States |
Package dimensions | ?" × ?" × ?" (50.0 lbs.) |
Shipping carriers | UPS or FedEx |
Shipping cost | Specified after purchase |
Original accessories | Remote Control, Box |
Average | Research Pricing |
I am the second owner of this integrated amp. The first owner had it about 1.5 years, and I have had it for only 1 month. It has a total of about 840 hours on it. When I bought the amp I first sent it to Audio Research to be examined and given a clean bill of health. It runs perfectly and looks like new. I am only rating it 8 out of 10 because I am the second owner, and not because of its condition. Amp includes the new KT120 tubes, and it was built especially for these tubes. It is a powerful amp that will drive most speakers. I have Magico Q3s and it drives them very nicely. I have the original box and all the packing material, so it will ship very safely. The unit is boxed and ready for shipping. I am selling because I just unexpectedly got a great price on another higher end amp, and I have decided to go in that direction. Buy with confidence; check my perfect feedback. Buyer pays shipping and 3% Paypal fees. In addition to Paypal I will accept a money order or certified check.
Here is information on the vsi 75 from the ARC website:
POWER OUTPUT
75 watts per channel continuous from 20Hz to 20kHz. 1 kHz total harmonic distortion typically 1.5% at 75 watts, .05% at 1 watt. Approximate actual power available at “clipping” 80 watts (1kHz). (Note that actual power output is dependent upon both line voltage and “condition” i.e. if power line has high distortion, maximum power will be affected adversely, although from a listening standpoint this is not very critical.)
POWER BANDWIDTH
(-3dB points) 12Hz to 70kHz.
FREQUENCY RESPONSE
(-3dB points at 1 watt) 1.0Hz to 70 kHz.
INPUT SENSITIVITY
0.55V RMS Single-ended for rated output. (32.5dB gain into 8 ohms.)
INPUT IMPEDANCE
52.5K ohms Single-ended.
INPUTS
(5) 1, 2, 3, 4, 5 (Single Ended RCA connectors).
MAXIMUM INPUT
10V RMS (any input).
OUTPUT POLARITY
Non-Inverting (any input).
PUSH BUTTONS
Volume up, Volume down (103 steps), Power, Input, Mute, Bias. All functions on IR remote control.
OUTPUT REGULATION
Approximately 2dB 8 ohm load to open circuit (Damping factor approximately 4).
OUTPUT TAPS
8 ohms, 4 ohms.
OVERALL NEGATIVE FEEDBACK
4dB.
SLEW RATE
10 volts/microsecond.
RISE TIME
4 microseconds.
HUM & NOISE
Less than 1.0 mV RMS -88dB below rated output (IHF weighted, Vol down).
POWER SUPPLIES
Electronically regulated Low and High voltage supplies for input stages. Automatic 40 sec. warm-up/brown-out mute.
POWER SUPPLY ENERGY STORAGE
Approximately 350 joules.
POWER REQUIREMENTS
100-125VAC 60Hz (200-250VAC 50Hz) 400 watts at rated output, 600 watts maximum, 210 watts at “idle’ 1.0 watt power off.
TUBES REQUIRED
2-Matched pair KT120-Power Output; 2 -6H30 driver.
DIMENSIONS
Width 14.5” (36.8 cm); Height 9.25” (23.5 cm); Depth 16.25” (41.3 cm); Rear connectors extend .88” beyond chassis.
WEIGHT
36.4 lbs. (16.5 kg) Net; 49.3 lbs. (22.4 kg) Shipping.
No questions have been asked about this item.
Ask the seller a public question
You must log in to ask a question.
Return Policy
Return Window
Returns are not accepted on this item.