Revel Sub15 Subwoofer only

Up for your bidding is a near perfect
condition Revel Sub15 passive subwoofer in Black  ... this is a no reserve
auction .. opening bid is at $825 .. PP fees are included in opening bid

 
Shipping and Insurance in lower 48 of
approximately 100 lbs should run between $70 and $100 ... Sub would ship from
06484 CT .. winner bidder pays only actual shipping cost to their zip code

 
Paypal fees ARE  included at my opening no
reserve bid  ... THERE IS NO ADDITIONAL FEES FOR PAYPAL only shipping 

 
Beautiful architectural style 15 inch passive
sub .. very compact doesn’t look like big black box 15 incher  ... view
pictures  ... does everything to aplomb with very low distortion
 
Low distortion is the key to a good subwoofer
and because  passive one uses  external crossovers and amps both the crossover
and amp are not compromised by cabinet’s vibration .. heat build up and the
magnetic forces of the speaker effecting your digital plate amp ... hence lower
distortion
 
The Revel Sub15  requires an external amp and
crossover ... you can also use the  “Sub” out from any HT  pre pro or integrated
HT AVR  ... just add an amp after sub out on processor
 
For two channel operation another option is to
add a Dayton SA1000  amp  497w@ 8 ohm  950w@4 ohm class A/B .. this stand alone
amp/controller  has all the controls built in to implement and integrate  the
Sub15 into your system
 
The Dayton has a Variable cross over point cut
off .. Volume control to blend to mains .. Phase switch and a single channel
Parametric EQ to reduce the floor to ceiling bounce that is present in every
room
 
These Dayton amps are available all over the
net for $400
 
THERE IS NO AMP OR CROSSOVER being offer with
this sub ... only suggesting the Dayton as a one box add on solution to setup
and drive the Revel Sub15
 
Sub is in immaculate condition with no marks
on the body or tears in grill  ..see pictures ...there may be some marks on the
bottom but not sure  ... I have the original Revel spikes and shipping cartoon
and will add extra packing to protect Sub as if it were a National Treasure

 
The SUB-15 utilizes a single, massive, 15"
driver with a 4" voice-coil. Its heavy paper cone is impregnated with Kevlar and
kapok. The voice-coil is a long-coil, edge-wound, 4"-diameter design, and the
magnetic structure alone weighs 36 pounds. The rated peak-to-peak excursion is
1.5".
 
Questions are welcome ... Thanks for Looking