McIntosh Mc 252

With 250 watts per channel at 0.005% maximum distortion across the entire audio spectrum, the MC252 provides clean energy a huge amount. McIntosh exclusive output auto-transformer provides the amplifier will always deliver full power, without stress, to any type of speaker. If the speakers used are 2, 4 or 8 Ohms, McIntosh Auto-formers ensure that every bit of power is used. , Superior protection of short-circuit fuse is provided by the least McIntosh Sentry Monitor circuitry. Guard power, an input / output comparator, responsive to 1/1000 of a second to eliminate amplifier clipping.

A polished stainless steel frame, front panel with high quality glass optics / lighting LED fiber front face and True Power Peak Power Meter Reply lends a look of pure elegance to this powerful amplifier.

EXCLUSIVE MCINTOSH ASSURANCE SYSTEM
A set of technologies that improve the performance and reliability
while protecting the amplifier and speakers.

POWER GUARD
A comparison circuit waveform control both continuously input and
output signals. Power Guard dynamically adjusts the input level to avoid clipping
while avoiding distortions hard survey.

SENTRY MONITOR
Fuse-less protection circuitry against short circuit disengages the output stage
before current exceeds safe operating level - resets automatically.
auto-transformer OUT

McIntosh unique technology offers the full power of the amplifier rated with
minimize distortion in speaker impedance of 2, 4 or 8 Ohms; you get all the power you paid for and the freedom to choose any loudspeaker.

WATTMETER
Fast and accurate response reveals program peaks so staying within the power of your speakers is easy.

MONO OPERATION
Both channels 250 watts can be combined into a single channel of 500 watts. Autoformers McIntosh exclusive output 500 watts allow this to be delivered in 1, 2, 4, 8 or 16 Ohm speakers.

* Exclusive McIntosh Power
* Assurance System
* High current capability
* High Bandwidth
* Fiber Optic Illumination glass 3D
* Front Panel
* Mono Capacity

RMS

250W min. (Stereo) or 500W min. (Mono and parallel bi-amplification) continuous sine wave average power from 20Hz to 20kHz.

Rated POWER BAND
20Hz to 20kHz

THD
Maximum total harmonic distortion at any level from 250 milliwatts to rated power output is 0.005%.

headroom
2.0dB

FREQUENCY RESPONSE
20Hz to 20kHz, +0 /-0.25dB
10Hz to 100kHz, +0 / -3 dB

Input sensitivity
1.6V 3.2V unbalanced balanced

A-weighted signal-NOISE
112dB below rated output

Inter modulation Distortion if the maximum instantaneous peak output by the channel does not exceed twice the nominal power, for any combination of frequencies from 20 Hz to 20 000 Hz, with all channels operating is 0.005%.

INPUT IMPEDANCE
10,000 ohms (unbalanced)
20,000 ohms (balanced)

POWER OUTPUT IMPEDANCE
Terminals for 2, 4 or 8 ohms (stereo)
Terminals 4, 8 or 16 ohms (mono)
Terminals 1, 2 or 4 ohms (parallel bi-amplification)